Installation guide

C–2 Converting a Single-Host Configuration to a Dual-Host Configuration
WARNING
The following procedure assumes that the SF200 storage array
and the SF72 storage enclosures and magazine tape subsystems
in the array have been correctly installed and configured
according to the standard bus and configuration guidelines in
this installation guide.
Locate the system configuration sheets (an example can be found
in Figure C–1) and ensure that it is filled out. If the system
configuration sheet does not exist then fill one out immediately.
CAUTION
Only one SF72 storage enclosure inner assembly should be
extended on slide mount at a time.
Take all possible ESD precautions when performing this
procedure. Wear a correctly grounded ESD strap.
Perform each step in the order they are presented.