Installation guide

Unpacking and Placing an SF200 Storage Array with a VAX 6000 Series System 3–3
3.2 Removing the SF200 Storage Array from the
Pallet
This section provides the procedure for removing the storage array from
the pallet and leveling the array. For personal safety, adhere to the
following WARNING before starting the procedure:
WARNING
Serious personal injury may result if correct safety conditions
are not met. During the unpacking procedure, personnel should
wear safety glasses. Inspect the ramps, ramp side rails, and metal
hardware for the following defects:
• Cracks more than 25 percent of the ramp depth, either across
or lengthwise on the ramp
• Knots or knotholes going through the thickness of the ramp
and greater than 50 percent of the ramp width
• Loose, missing, or broken ramp side rails
• Loose, missing, or bent metal hardware
If any of these defects exist, DO NOT USE THAT RAMP.
Investigate alternate means of removing the array or order a
new ramp. The part number for the left ramp is 99–07689–01; the
part number for the right ramp is 99–07689–02.