Installation guide

Installing the Magazine Tape Subsystem in an SF200 Storage Array 6–39
8. If there is no SF72 storage enclosure installed in position 2, then
at the rear of the SF200 storage array, locate the DSSI I/O panel at
the bottom. Use a 3/16-inch flatblade screwdriver to loosen the two
captive screws at the right of the panel.
9. Swing open and remove the panel from the cabinet frame.
CAUTION
Use care not to disturb or damage power cords and DSSI
cables that are already connected to the DSSI I/O panel.
10. Install a 70-inch DSSI cable (part number BC21R–5L) to port 2 on the
SF200 storage array I/O panel by first removing the panel blank.
11. Connect the other end of this 70-inch DSSI cable to the top DSSI
connector on the rear of the magazine tape subsystem.
12. Install a 70-inch DSSI cable (part number BC21R–5L) to port 10 on
the SF200 storage array I/O panel by first removing the panel blank.
13. Connect the other end of this 70-inch DSSI cable to the bottom DSSI
connector on the rear of the magazine tape subsystem.