Installation guide

6–32 Installing the Magazine Tape Subsystem in an SF200 Storage Array
9. If no SF72 storage enclosure is installed in position 2, then at the rear
of the SF200 storage array, locate the DSSI I/O panel at the bottom.
Use a 3/16-inch flatblade screwdriver to loosen the two captive screws
at the right of the panel.
10. Swing open and remove the panel from the cabinet frame.
CAUTION
Use care not to disturb or damage power cords and DSSI
cables that are already connected to the DSSI I/O panel.
11. Remove the two Phillips screws that hold the panel blank in port 2 of
the I/O panel.
12. Install a 70-inch DSSI cable (part number BC21R–5L) in place of the
panel blank you just removed in the previous step.
13. Connect the other end of this cable into the top DSSI connector at the
rear of the magazine tape subsystem. Refer to Figure 6–13.
14. Route this DSSI cable under the cable retainers on the left side of the
cabinet.
15. Connect a 108-inch DSSI cable (part number BC21Q–09) into the port
you just install in the previous steps. Tighten the retainer screws on
this with your fingers.