Installation guide

Installing the Magazine Tape Subsystem in an SF200 Storage Array 6–31
6. At this time, connect a 42-inch DSSI cable (part number BC21Q–3F)
to the rightmost DSSI connector at the rear of the SF72 in position
2 and to the bottom DSSI connector at the rear of the magazine tape
subsystem in position 6.
7. Route this DSSI cable under the cable retainers on the appropriate
side of the cabinet.
8. Push the inner assembly back into the extrusion tube.
CAUTION
Use care not to disturb or damage power cords and DSSI
cables that are already connected to the DSSI I/O panel.