Installation guide

6–26 Installing the Magazine Tape Subsystem in an SF200 Storage Array

6.2 Cabling the Subsystem in SF200 Storage Array

Position

This section describes the step-by-step procedure to cable the magazine

tape subsystem that you just installed to the existing DSSI bus

conﬁguration of the SF200 storage array.

Refer to Section 6.2.1 for instructions on how to cable the magazine

tape subsystem in an SF200 storage array conﬁgured for single-host.

Refer to Section 6.2.2 for instructions on how to cable the magazine tape

subsystem in an SF200 storage array conﬁgured for dual-host.

6.2.1 Single-Host Conﬁguration