Installation guide

Installing the Magazine Tape Subsystem in an SF200 Storage Array 6–23
d. At the front of the cabinet, lift the extrusion tube up and onto
the slide mount until the chassis retainers touch the weldment
brackets.
e. Install and tighten the two outer weldment screws, then install
and tighten the two inner weldment screws (Figure 6–9).
f. Tighten the upper and lower weldment 1/2-inch shoulder screws
and washers.
SHR-X0132A-90
LOCK WASHER (2)
90-07651-03
1/2-INCH PHILLIPS
SCREW (2)
CHASSIS RETAINER (2)
74-35858-01
SLIDE MOUNT
HARDWARE
HERE IS
SAME AS
LISTED
ABOVE
1 1/2-INCH PHILLIPS
SCREW (2)
90-06079-03
90-06079-02
Figure 6–9 Securing the Tube to the Weldment Brackets