Installation guide

Installing the Magazine Tape Subsystem in an SF200 Storage Array 6–21
3. Install the magazine tape subsystem.
a. Loosen the shipping screw in the rear, upper right corner, of the
magazine tape subsystem.
b. Remove the magazine tape subsystem assembly from the
extrusion tube. Push the inner assembly out to the first
mechanical stop. Release the stop and then push the inner
assembly out to the second mechanical stop. Then remove the
inner assembly from the extrusion tube. Place the inner assembly
off to one side.
CAUTION
Do NOT open the front of the magazine tape subsystem
inner assembly while the inner assembly is out of the
extrusion tube.
c. Install both chassis retainers on the front, right side (position
5) or left side (position 6) of the extrusion tube (top and bottom,
Figure 6–8).