Installation guide

Installing the Magazine Tape Subsystem in an SF200 Storage Array 6–17
h. While facing the rear of the cabinet, install two 7/16-inch shoulder
screws with washers (hand-tighten) — one screw in the bottom
threaded hole and the other in the threaded hole beneath the
center rear shoulder screw (hand-tighten) previously installed.
i. While facing the front of the cabinet, install two 7/16-inch
shoulder screws with washers (hand-tighten) — one screw in
the bottom threaded hole and the other in the threaded hole
beneath the center rear shoulder screw (hand-tighten) previously
installed.
j. Tighten all shoulder screws.
k. Tighten the four slide mount screws.