Installation guide

6–14 Installing the Magazine Tape Subsystem in an SF200 Storage Array
6.1.4.2 Hardware Installation Procedures
Perform the following steps in full and in the order presented.
WARNING
Before performing the following steps, refer to the system
documentation for the correct steps to peform an orderly
shutdown of the system that the SF200 storage array is connected
to.
1. Install the ac power cord (Figure 6–5).
a. Swing open and remove the panel from the cabinet frame.
CAUTION
Use care not to disturb or damage power cords and DSSI
cables that are already connected to the DSSI I/O panel.
b. Locate the ac power cord retainer bracket at the third level of the
SF200 storage array cabinet.
c. Loosen lower screw of the ac retainer bracket. Remove the upper
ac power cord retainer bracket screw and tilt the retainer 45
degrees. Then retighten the lower screw.
d. Place ac power cord in the retainer space with the shrouded male
plug end inside cabinet side rail.
e. Loosen the lower screw and put the retainer bracket back to its
original position. Then reinsert the upper screw and tighten both
the top and bottom screws.
f. Connect the male end of the ac power cord to the first available
outlet on the 881 power controller.