Installation guide

Installing the Magazine Tape Subsystem in an SF200 Storage Array 6–11
6.1.4 Installion Procedure
This section describes the step-by-step procedures for installing a
magazine tape subsystem in an SF200 storage array.
Be sure to:
• Follow each step in order, and do not skip any steps
• Leave sufficient room to perform the installation (approximately 1.5
meters to 1.8 meters [5 feet to 6 feet] front and rear of the array)
CAUTION
Observe all ESD precautions and procedures.
An antistatic wrist strap is inside the front and rear doors.
CAUTION
Do not attempt to pick up or support the product by the rear of
the enclosure. Doing so will injure the person attempting the
installation or damage the power supply.