Installation guide

5–38 Installing the SF72 Storage Enclosure in an SF200 Storage Array
6. Route this DSSI cable under the cable retainers on the right side of
the cabinet. Cabling the magazine tape subsystem with the inner
assembly pulled out to the head-cleaning position ensures that the
correct cable slack will be provided when the inner assembly is
pushed back into the extrusion tube.
7. Push the inner assembly of the magazine tape subsystem back into
the extrusion tube.
8. Connect the 42-inch DSSI cable from the bottom DSSI connector on
the rear of the magazine tape subsystem in position 5 to the rightmost
DSSI connector on the rear of the SF72 storage enclosure in position
1.