Installation guide

Installing the SF72 Storage Enclosure in an SF200 Storage Array 5–37
5.2.1.2 Cabling Position 1
WARNING
Before performing the following steps, refer to the system
documentation for the correct steps to perform an orderly
shutdown of the system that the SF200 storage array is connected
to.
The following steps are for cabling position 1 with a magazine tape
subsystem in position 5:
CAUTION
Use care not to disturb or damage power cords and DSSI
cables that are already connected to the DSSI I/O panel.
1. Tighten the shipping screw in the rear, upper right corner, of the
magazine tape subsystem in position 5.
2. Remove the DSSI terminator from the bottom DSSI connector on the
rear of the magazine tape subsystem in position 5.
3. Install a 42-inch DSSI cable (part number BC21Q–3F) in the bottom
DSSI connector on the rear of the magazine tape subsystem in
position 5 (Figure 5–18).
4. Loosen the shipping screw in the rear, upper right corner, of the
magazine tape subsystem in position 5.
5. Pull the inner assembly of the magazine tape subsystem out to the
head-cleaning position (first mechanical stop).