Installation guide

5–32 Installing the SF72 Storage Enclosure in an SF200 Storage Array
5.2 Cabling the SF72 in Storage Array Position
This section describes the step-by-step procedure to cable the SF72
storage enclosure that you just installed to the existing DSSI bus
configuration of the SF200 storage array.
Refer to Section 5.2.1 for instructions on how to cable the SF72 storage
enclosure in an SF200 storage array configured for single-host. Refer to
Section 5.2.2 for instructions on how to cable the SF72 storage enclosure
in an SF200 storage array configured for dual-host.
Once the cabling of the SF200 storage array is complete, each bus must be
connected to match one of the following eight buses. Figure 5–16 shows
the five possible single-host configurations, and Figure 5–17 shows the
three possible dual-host configurations.