Installation guide

5–22 Installing the SF72 Storage Enclosure in an SF200 Storage Array
4. Do the following if you are installing an SF72 in position 3 or 8
(single-host only):
CAUTION
To maintain stability, extend only one SF72 storage enclosure
or magazine tape subsystem on the slide mounts at a time.
a. Loosen the four captive slide assembly screws. Slide the inner
assembly out until the drawer locks in the service position.
b. Push the inner assemply forward from the rear.
NOTE
Do NOT completely remove the SF72 inner drawer
assembly from the extrusion tube and extend only one
at a time.
c. Reconfigure the TTM for split-bus mode by first moving the
small black jumper to the split-bus terminals, then moving cable
connectors to the right pair of sockets.
d. Push the SF72 inner drawer back in, replace the front cover door,
and tighten the four front door screws. To prevent pinching any
cables, be sure that all cables are dressed correctly.