Installation guide

5–20 Installing the SF72 Storage Enclosure in an SF200 Storage Array

b. At the front of the cabinet, hoist the SF72 assembly by using the

lifting device or three people to lift the SF72 storage enclosure up

and onto the slide mount. Push the assembly halfway into the

cabinet.

c. From the rear of the storage array, pull the SF72 assembly all the

way onto the slide mount until the chassis retainers contact the

weldment brackets.

d. Install and tighten the two outer weldment bracket screws,

then install and tighten the two inner weldment bracket screws

(Figure 5–9).

e. Tighten the upper and lower weldment 1/2-inch shoulder screws

and washers.