Installation guide

Installing the SF72 Storage Enclosure in an SF200 Storage Array 5–17
l. From the front of the cabinet, install the upper and lower
weldment brackets on the cabinet side rail using 1/2-inch shoulder
screws and washers (Figure 5–7).
The center hole of the weldment bracket goes over the guide pin
on the slide mount so the large end of the top weldment bracket
points up and the large end of the bottom weldment bracket points
down, regardless of whether you are installing the brackets on the
front right or left cabinet frame rails.
NOTE
Do NOT tighten the screws at this time.