Installation guide

5–16 Installing the SF72 Storage Enclosure in an SF200 Storage Array
h. While facing the rear of the cabinet, install two 7/16-inch shoulder
screws with washers (hand-tighten) — one screw in the bottom
threaded hole and the other in the threaded hole beneath the
center rear shoulder screw (hand-tighten) previously installed.
i. While facing the front of the cabinet, install two 7/16-inch
shoulder screws with washers (hand-tighten) — one screw in
the bottom threaded hole and the other in the threaded hole
beneath the center rear shoulder screw (hand-tighten) previously
installed.
j. Tighten all shoulder screws.
k. Tighten the four slide mount screws.
LOCKWASHER (5)
90-06637-00
7/16-INCH SHOULDER SCREW (3)
12-24007-02
DSSI CABLE RETAINER
74-41302-01
LOCKWASHER (3)
90-06637-00
SLIDE MOUNT
NOTE TO ILLUSTRATOR:
This is reduced at 18%
of original
7/16-INCH
SHOULDER
SCREW (3)
12-24007-02
1/2-INCH
SHOULDER
SCREW (2)
12-24007-01
SHR-X0130A-90
Figure 5–6 Installing the Slide Mount