User manual

Chapter 5 – Monitoring Features
PS-2000B Series User Manual
5–14
5.3.3 Setup and Preparation of the Remote RAS Feature
In order to monitor the System Monitor/RAS features from the server PC, you are
required to set up the Remote RAS feature and start up the System Monitor
(PSB_Smon.exe).


 Setting Up the Client PS-B
(1) Select [Start] → [Programs] → [System Monitor] → [System Monitor Prop-
erty] commands to start the System Monitor Property.
(2) On the [Remote Ras] tab, put a check mark to the [Enable] checkbox.
The Remote RAS feature is now enabled.
In order to actually activate the Remote RAS feature, you are
required to start up the System Monitor (PSB_Smon.exe) within
the PS-B.


 Setting Up the Server PC
(1) Start up the Pro-Studio.
(2) Register the PS-B you want to include in the network to the network station,
and edit the participant stations.
Pro-Server with Pro-Studio for Windows Operation Manual
When using the Pro-studio’s [Find Stations] command to reg-
ister the PS-B to the network station, the System Monitor should
be activated with the Remote RAS feature enabled in the PS-
B.
(3) Select [PL, PS-B] for the PLC type on the network station editing.
(4) When registering the symbol, refer to the List of Device Address for the
symbol that can be registered.
Specify the IP
address of the
server you
want to com-
municate with.
This feature
designates that
the PS-B will
communicate only
with the server at
the specified IP
address.
Put check
marks on the
items you want
to monitor.
IP Address used
to connect with
Pro-Server
*1
*1 When allocating 2 or more IP Addresses to the PS-B unit, [Auto] cannot be selected.
Enter settings that allow the reading of a fixed IP Address from a DHCP server. For
details, contact your company’s network administrator.