User manual

PS-2000B Series User Manual
4–5
Chapter 4 – Setting up Your PS-B Unit


 Setting Up the PS-B Unit's System Information
If your PS-B unit does not have a pre-installed HDD, you will need to install an
HDD unit and then configure that drive's system information. Be sure to check
that the system successfully recognizes the drive.
Pre-installed HDD Unit Installation Guide


 Setting Up an HDD with Pre-installed OS
Follow the setup procedures given in the Pre-installed Type HDD Unit Installation
Guide.


 PS-B Hard Disk Data
Setting up the PS-B unit's utilities will create a [Proface] folder on the C drive.
The following diagram describes the configuration of this folder.
• The actual organization may differ depending on your PS-
B unit's OS.
• Setting up the PS-B unit's utilities automatically copies the
hardware control driver (PSSYSMON.SYS) to the system
folder.
[Proface]
[PsbApi] API-DLL
[Audio] Audio Driver
[Chipset] Chipset Driver (Not included with Windows
®
XP)
[Display] Graphic Accelerator Driver
[Setup] CD Image
[Shutdown]
[Client] Remote Shutdown Client
[Sysmon] System Monitor/RAS Application