User manual

Chapter 4 – Setting up Your PS-B Unit
PS-2000B Series User Manual
4–4
• The actual organization may differ depending on your PS-
B unit's OS.
• Setting up the PS-B unit's utilities automatically copies the
hardware control driver (PSSYSMON.SYS) to the system
folder.
4.2.2 Setting Up an HDD with Pre-installed OS
Use the following steps to set up your PS-B unit's HDD unit, which contains the
Windows
®
2000 or Windows
®
XP operating system, related drivers and utility
software.
• Each pre-installed operating system is designed specially
for the PS-B unit.
• "Service Pack 4" is included in the Windows
®
2000 HDD
unit.
• "Service Pack 2" is included in the Windows
®
XP HDD unit.


 Installing the HDD Unit
After opening the PS-B unit's packing box, check that a hard disk unit is installed.
If it is not, you will need to install it.
Pre-installed HDD Unit Installation Guide
[Proface]
[PsbApi] API-DLL
[Audio] Audio Driver
[Chipset] Chipset Driver (Not included with Windows
®
XP)
[Display] Graphic Accelerator Driver
[Shutdown]
[Client] Remote Shutdown Client
[Sysmon] System Monitor/RAS Application


 PS-B Hard Disk Data
Setting up the PS-B unit's utilities will create a [Proface] folder on the C drive.
The following diagram describes the configuration of this folder.