User manual

Chapter 3 - System Setup
PS-2000B Series User Manual3-10
Item Help
Menu Level
Selecting INTEGRATED PERIPHERALS SETUP menu item Displays the fol-
lowing screen.
On-Chip Primary (Secondary) PCI IDE
Designates the internal IDE port's setting. The two selections available are
[Disabled] and [Enabled]. The [Enabled] selection is factory set and recom-
mended for most users.
IDE Primary (Secondary) Master (Slave) PIO
Designates the Primary (Secondary) Master Drive's PIO (Programmed Input/
Output) Operation Mode. The selections available are [Auto], [Mode0],
[Mode1], [Mode2], [Mode3], or [Mode4]. The [Auto] selection is factory set
and recommended for most users.
IDE Primary (Secondary) Master (Slave) UDMA
Designates the Primary (Secondary) Master Drive's UDMA Operation Mode.
The two selections available are [Auto] or [Disabled]. The [Auto] selection is
factory set and recommended for most users.
USB Controller
Select [Enabled] or [Disable] when attaching a USB device. The [Disabled]
selection is factory set and recommended for most users. When using the USB
I/F or the USB connector for connecting the touch panel, set this item to
“Enabled”.
On-Chip Primary PCI IDE [Enabled]
On-Chip Seconary PCI IDE [Enabled]
IDE Primary Master PIO [Auto]
IDE Primary Slave PIO [Auto]
IDE Secondary Master PIO [Auto]
IDE Secondary Slave PIO [Auto]
IDE Primary Master UDMA [Auto]
IDE Primary Slave UDMA [Auto]
IDE Secondary Master UDMA [Auto]
IDE Secondary Slave UDMA [Auto]
USB Controller [Enabled]
USB Keyboard Support [Auto]
USB Mouse Support [Disabled]
Init Display First [PCI Slot]
AC97 Audio [Enabled]
Onboard LAN1 [Enabled]
Onboard LAN2 [Enabled]
IDE HDD Block Mode [Enabled]
Onboard FDC Controller [Enabled]
Onboard Serial Port 1 [3F8/IRQ4]
Onboard Serial Port 2 [2F8/IRQ3]
Onboard Parallel Port [Disabled]
x Parallel Port Mode SPP
x EPP Mode Select EPP1,7
x ECP Mode Use DMA 3
Onboard Serial Port 3 [3E8]
Serial Port 3 Use IRQ [IRQ11]
Onboard Serial Port 4 [2E8]
Serial Port 4 Use IRQ [IRQ10]
Phoenix - AwardBIOS CMOS Setup Utility
Integrated Peripherals
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
3.2.5 Integrated Peripherals