User manual

Chapter 2 – Hardware Installation

PS-2000B Series User Manual

2–10

• Be sure that power is not being supplied to the PS-B when

connecting the power cord; otherwise, electrical shocks or

product breakdown may result.

• Be sure that the PS-B is operated under the rated power sup-

ply voltage; otherwise, a fire, electrical shock hazards, and

product breakdown may result.

WARNINGS

Be sure to follow the procedure below to connect the power cord.

(1) Be sure that the PS-B is turned off.

(2) Remove the terminal cover by using a Phillips screwdriver.

(3) Unscrew and remove the middle screws (3) from the terminal block. Next,

align each crimp contact

with its screw hole and tighten the screw.

Ø3.2 mm[0.13] min.

6.0 mm

[0.24] max.

Black

White

Green/Yellow

1. Recommended crimp contact: Equivalent of V1.25-3 manufactured by J.S.T. Mfg Co., Ltd.

2.3 Wiring

2.3.1 Connecting the Power Cord

Connect the power cord to the power input terminal located on the front face of the

PS-B unit.

Power Input Terminal

Input terminal for the power supply

of AC 100V/AC 240 V. "L" is for the

live state and "N" is for the neutral

state.

Ground terminal

connected to the

enclosure of the PS-

Power Input Terminal Block

Power Switch