User manual

PS-2000B Series User Manual
Chapter 2 – Hardware Installation
2–9
Installed Horizontally
(With CD-ROM/FD drive unit attached)
Be sure not to use excessive force when tightening the screws. Prod-
uct damage can result from over-tightening. The appropriate tightening
torque is from 1.0 to 1.2 N•m.
2. Drill installation screw holes in the panel.
Be sure to follow the dimensions given for the installation slots and prepare, if
necessary, the installation surface of the panel (i.e. attach supports, etc.).
1.5.4 With Mounting Bracket Attached Attachment Bracket
Attachment Screw Hole Dimensions
3. Attach the PS-B main unit to the panel using M4 screws.
First, insert the screws to the installation holes on the panel. However, do not
tighten the screws at this point. Next, install the PS-B unit in the panel by
hanging the mounting bracket screws holes over the screw heads. Finally,
tighten all mounting bracket screws to secure the PS-B unit in place.
Screw
Installed Vertically
Installed Horizontally
Screw Screw Screw