User manual

PS-2000B Series User Manual
2–1
Chapter
2 Hardware Installation
1. Installing Optional Units and
Expansion Boards
2. Installing the PS-B Unit
3. Wiring
This chapter describes the installation of optional units and expansion boards, as
well as the PS-B unit setup and wiring procedures.
2.1 Installing Optional Units and Expan-
sion Boards
A wide variety of optional units and expansion boards (PCI bus compatible board
*1) manufactured by Digital Electronics Corporation can be used with the PS-B.
Unscrew the four (4) cover attachment screws, and remove the cover. Install the
desired unit and/or expansion board as shown in the " PS-B Internal View"
drawing.
For the detailed optional unit installation procedures, refer to that unit's "Installa-
tion Guide".
•
Be sure to disconnect the power cord from the power supply
and confirm that power is not supplied to the PS-B unit be-
fore installing any optional units or expansion boards. Failure
to do so can result in an electric shock.
WARNINGS
• Use a screwdriver to loosen and tighten the screws. Be sure not to
tighten the screws too tightly. Excessive force can damage the equip-
ment.
• When removing or replacing screws, be careful that they do not fall
inside the PS-B unit's chassis.
1. Including PCI 2.20.