User manual

Chapter 1 – PS-B Unit Basics
PS-2000B Series User Manual
1–2
When using a Flat Panel Display (FP) as a touch panel, addi-
tional preparation steps are required. After all device drivers
are installed, complete the following steps prior to installing
applications and the PS-B unit.
FP Series User Manual
Perform Calibration
• After hardware setup is completed, the OS must be used to create
partitions and format (initialize) the HDD before any data or applica-
tions can be saved to the hard disk drive. For details concerning
these procedures, refer to the OS manufacturer's instruction manual.
• Whenever you turn the PS-B unit's power OFF, wait until the internal
HDD stops spinning (approximately 5 seconds) before turning the
power ON again.
Install Mouse Emulation Software
Set up Display Parameters
(color and resolution)