User manual

PS-2000B Series User Manual

Preface

CE Marking Notes

The PS2000B-41 units are CE marked, EMC compliant products.

• Safety

EN60950

• EMI

EN55011 Group1 (Class A), EN61000-3-2, EN61000-3-3

• EMS (EN61000-6-2)

EN61000-4-2, EN61000-4-3, EN61000-4-4, EN61000-4-5, EN61000-4-6,

EN61000-4-8, EN61000-4-11

If following requirements are not met, the PS-B may fail to meet EN60950 stan-

dard requirements.

• The PS-B should be used as a built-in component of an end-use product.

• The PS-B is intended for indoor use only.

• When connecting the PS-B unit's power cord, be sure to use a cord that is

appropriate for the current and voltage used, and that has conductive wires that

are 0.75 mm2 or larger.

• When an end-use product will include the PS-B, be sure to design the PS-B

unit's power cut-off switch as a separate disconnect device and locate it where

the operator can easily reach it.

• There is a danger of explosion if the PS-B unit's backup battery is incorrectly

replaced. This battery should be replaced only with same or equivalent type

recommended by the manufacturer. Dispose of used batteries according to the

manufacturer's instructions.

• Be sure the unit the PS-B is built into uses an EN60950 approved structure.