Unit installation

-11-
The HDD unit's installation and system data settings are as follows.
1) Install the HDD unit in the PS-B. Refer to 2 Installation for details. If the
HDD unit is already installed, this step is not necessary.
2)Connect a keyboard to the PS-B.
3)Turn on the PS-B unit's power supply and use the following steps to set up
the system data and recognize the HDD unit.
• Normally, use the factory (initial) settings.
• Your PS-B unit's system data screen menus may differ slightly from
these due to installation of newer software.
• The following explanation uses the PS-B unit's factory settings.
3 Hardware Setup
4)When the start-up screen appears, press your PC’s [F2] key to go to the
BIOS Setup Screen.In the Setup Screen, select [Standard CMOS Features],
then select [IDE Primary Master]. The following screen will appear.
5) Confirm whether "AUTO" is selected for IDE Primary Master. Also, con-
firm whether "AUTO" is selected for the [Access Mode]. If AUTO is not
selected, change these settings to AUTO. If AUTO is selected in both, disk
parameters will be automatically read when the PS-B is turned ON. The
factory setting is AUTO and recommended for most users.
6) After all changes are made, press the ESC key and select [Save & EXIT
Setup] to save the settings. The OS will then start.
IDE HDD Auto-Detection [Press Enter]
IDE Primary Master [Auto]
Access Mode [Auto]
Capacity 0 MB
Cylinder 0
Head 0
Precomp 0
Landing Zone 0
Sector 0
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
Phoenix- AwardBIOS CMOS Setup Utility
IDE Primary Master
Item Help
Menu Level
To auto-detect the
HDD's size, head...on
this channel