Installation guide

11
5 Installing the PS-B
1) Use the four (4) attachment screws included in the PS-B’s packing box to
attach the mounting brackets to the PS-B main unit. Be careful that each
bracket is attached to the correct side.
Use the following procedures to install the PS-B into a solid panel.


 External Output Signal (DOUT Port)
Be sure to operate the unit within its maximum load current. If the maxi-
mum load current exceeds this range, a malfunction or PS-B damage may
occur.
Rated Load Voltage DC12V to DC24V
Maximum Load Current
100mA/point
Maximum Voltage Drop between Terminals 1.5V (at 100mA load current)
Isolation Method Via photocoupler
DOUT0(+), DOUT1(+)
DOUT2(+), DOUT3(+)
(Interface Circuit) (Connection Example)
+5V
R
Cable
D-sub 25 pin Connector
4.7kΩ
PC357
SSTA06
DC12 to DC24V
*1
Load
DOUT0(-), DOUT1(-)
DOUT2(-), DOUT3(-)
When Installing the PS-B vertically