User`s guide

Installing Additional Memory
6-10
6. Install a SIMM into a socket at a 45 degree angle away from the
edge connector.
Make sure the notch is oriented as shown (A, Figure 6-5). Rock the
SIMM gently until it completely engages the bottom of the socket.
Tip the SIMM upright until both retaining clips engage (B, C, Figure
6-5).
7. Install the remaining SIMMs in complete banks on memory
modules 1 and 2.
NOTE: Half of banks 1, 2, and 3 are on each memory
module.
Refer to the Memory Configuration Guidelines section .
8. Replace both memory modules and secure them with the retaining
brackets.
9. Replace and lock the left side panel.
10. Connect all external devices and restore power.
11. Run the SCU. Select Configure Computer from the main menu,
and then select Save and Exit to configure your server for the
additional memory.
Refer to Chapter 2, “Server Utilities.”