User`s guide

Upgrading Your Server’s CPU Module Configuration
5-6
7. Install the regulators in their appropriate slots on the CPU module.
Refer to Appendix A, “Technical Specifications,” Figure A-2 for the location of
the regulator slots.
8. Install the CPU module in slot 2. Install the retaining bracket and
secure the captive screw located on the bracket to the chassis.
CAUTION: Make sure you align the CPU module with the
corresponding slot number on the card guide label. Failure
to do so might cause faulty CPU module and/or server
operation.
Also, the CPU module has two rows of gold fingers on its
edge that plug into the main logic board slot. The CPU
module must be pushed firmly in the slot to engage both
rows of gold fingers or your server might not power up on
boot.
9. Replace and lock the left side panel.
NOTE: Your server will not power up with the side panel
removed.
10. Connect all external devices and restore power.
11. Run the SCU, select Configure Computer, select View and
Edit Details, and then select Save and Exit.
This allows your server to recognize the new CPU module
configuration.
Refer to Chapter 2, “Server Utilities.”