User`s guide

Server Utilities
2-6
Starting the SCU
The SCU is located on your ServerWORKS Quick Launch CD-ROM disk.
The SCU options are shown in Figure 2-1. If this is your first time using the
SCU, it is recommended that you select “Learn About Configuring your
Computer” for detailed information on using the SCU. If this is a
subsequent session, refer to the appropriate sections in this chapter to
change your server’s configuration.
You can start the SCU in one of three ways:
1. During the Quick Launch boot process, if you selected “to create a
MS-DOS partition,” the SCU was copied to the MS-DOS partition
on your hard disk drive. This allows you to run the SCU anytime
from the MS-DOS partition.
At the MS-DOS prompt change to the SCU directory and type:
SCU.BAT
2. Using the Install Software/Conventional method in ServerWORKS
Quick Launch, you can create a bootable SCU diskette.
Afterwards, you can run the SCU anytime using the diskette you
created.
3. You can also run the SCU by inserting the Quick Launch CD-ROM
disk, rebooting the server, and pressing the right [ALT] key during
the boot process to display the SCU.
NOTE: If EISA or PCI cards have been added to your
server, the SCU will be invoked automatically when you boot
from the Quick Launch CD-ROM disk. The .SCI file is not
saved when you use this method to run the SCU.