User`s guide

Server Utilities
2-2
SCSI Select Utility
Your Prioris server comes with an Adaptec controller and an onboard
SCSI
Select configuration utility. This utility allows you to change host
controller settings without opening your server or handling the SCSI
controller board.
Use SCSI
Select to:
• Check factory default settings for each device on the SCSI bus.
• Change SCSI device settings that might conflict with other SCSI
devices.
• Perform low-level formatting on new SCSI disk drives.
You must let the Adaptec controller spin up the drive before
pressing [Ctrl] + [A] so you can perform low-level formatting.
To start the SCSI
Select configuration utility:
Press [Ctrl] + [A] when the Adaptec BIOS banner appears during the boot
process and before the end of the device information display.
RAID Configuration Utility
RAID-ready Prioris servers include a Mylex RAID controller and RAID
configuration utility. If your RAID controller was factory installed, the RAID
configuration utility appears when you boot your server with the
ServerWORKS Quick Launch CD-ROM disk. Use this utility to configure
your RAID array.
Refer to the Mylex User’s Manuals for more information.