User`s guide

Server Security Features
10-5
If You Forget Your Password
Use the following procedure to erase a password from your server.
1. Turn off your server and remove the left side panel.
2. Change switch J35-SW4 to password clear (switch on).
Refer to Appendix A, “Technical Specifications,” Main Logic Board Switch
Settings, and Figure A-1 for additional information.
3. Reconnect your server and turn it on.
Booting your server with this switch in the down position erases the
existing password(s).
4. Turn off your server and remove the left side panel.
5. Change switch J35-SW4 to normal mode (switch up).
6. Reconnect your server and turn it on.
7. Using the SCU, assign a new password.
Refer to Appendix C, “SCU Features,” for more information.