User`s guide

Server Security Features
10-4
Supervisor Password
Your server has a password level that you can set to prevent unauthorized
access to your server files. If you set a supervisor password, you will be
prompted to enter it prior to accessing the SCU. If “Password On Boot” is
enabled, you will be prompted to enter a password before your operating
system boots.
Perform the following steps to set a supervisor password:
1. Turn on your server and allow the POST to complete.
If POST detects an error refer to Chapter 4, “Server Management,”
and take the appropriate steps to correct the problem. After the
problem has been resolved, restart the server.
2. Either start the SCU from the MS-DOS partition or insert the SCU
diskette into drive A and soft boot (reset) your server.
3. Press [Enter] to display the Main menu, select the
Configure
Computer
option, then select the View and edit details
option.
4. Highlight the
Security Options Group and then press [Enter].
5. Highlight the
Supervisor Password field and then press [Enter].
6. Select
Installed.
7. Type in a supervisor password and then press [Enter].
To confirm, type in your supervisor password a second time and
then press [Enter].
8. Highlight the
Password On Boot field and select Enabled if
desired.
9. Exit the SCU and reboot your server so changes immediately take
effect.
Your computer runs the POST and then prompts you for the
supervisor password you set.