User`s guide

Connecting SCSI and RAID Adapters
9-3
Host Adapter Cable Configurations
The following sections describe the available host adapter cable
configurations for your Prioris ZX 6000MP Series.
Single Channel SCSI Configuration
To connect SCSI devices to a single channel, perform the following:
1. Power down the server.
2. Disconnect all peripheral devices from the server.
3. Unlock and remove the server side panel.
4. Connect the SCSI cables as shown in Figure 9-1.
5. If using the top 5¼-inch drive bay, connect the appropriate power
cable to the device.
6. Replace and the lock side panels.
7. Connect all external devices and then power on your server.
8. Run the SCU and/or RAID utilities to configure your server.
Refer to Chapter 2, “Server Utilities,” and to your SCSI and RAID
documentation for additional configuration information.
NOTE: Servers with this configuration are shipped with an
additional terminator to enable you to split the storage
backplane.