User`s guide

Installing Expansion Boards
8-20
Relocating Expansion Boards
Perform the following steps before relocating an ISA expansion board and
after relocating an EISA or PCI expansion board.
1. Start the SCU using one of the three methods described in
Chapter 2, “Starting the SCU.”
2. Press [Enter] to display the SCU main menu and then [Enter] again
to continue.
3. Select step 2 from the Configure Your Computer menu:
Adding and Removing Boards.”
4. Highlight the expansion board you want to relocate, press [Enter],
and then follow the instructions displayed on your monitor screen.
5. Select “Step 5: Save and Exit,” to save your configuration and exit
the SCU.
If there are no resource conflicts, the new configuration information
is saved to the .SCI file. If there is a conflict, you must resolve it
before you can complete your server’s configuration.
NOTE: If you run the SCU from the ServerWORKS Quick
Launch CD-ROM disk, the .SCI file is not saved. To save the
.SCI file, you need to rerun the SCU from either your hard
disk drive or from the SCU diskette you created.