User`s guide

Installing Expansion Boards
8-12
Adding ISA Expansion Boards
Perform the following steps before installing ISA expansion boards:
1. Start the SCU using one of the three methods described in
Chapter 2, “Starting the SCU.”
2. Select step 2 from the Configure Your Computer menu:
Adding and Removing Boards,” and update the list of expansion
boards and options to include any ISA expansion boards you are
going to install in your server.
3. Select “Step 4: Examine Switches or Print Report,” to check the
required switch and jumper settings of the ISA expansion boards.
4. Select “Step 5: Save and Exit,” to save your configuration and exit
the SCU.
5. Turn off your server and install the ISA expansion boards, manually
setting the necessary switches and jumpers.
Refer to “Installing ISA Expansion Boards.”
Installing ISA Expansion Boards
To install an ISA expansion board:
NOTE: Read and fully understand your optional expansion
board's documentation before installing the expansion
board.
1. Run the SCU.
2. Turn off your server.
3. Disconnect the external devices, ac power, and monitor power.
4. Unlock and remove the left side panel.
5. Unscrew and remove the metal filler plate from the selected ISA
expansion slot.