User`s guide

Installing Optional Disk and Tape Drives
7-22
Connecting an External Device to a SCSI Controller
To connect an external SCSI bus to a controller:
1. Power down the Prioris ZX 6000MP Series server.
2. Unlock and remove the left side panel.
3. Using a screwdriver, gently pry away one of the SCSI knockouts
located on the rear air flow panel (D, Figure 7-7).
4. Connect the wide SCSI 68-pin unshielded cable connector (part
no. FR-PCXAR-WG) from the inside connector on the knock-out
panel to the external SCSI connector on the SCSI controller.
5. Screw the appropriate (wide SCSI 68-pin or narrow SCSI 50-pin)
external shielded connector to the selected connector on the
outside of the knock-out panel.
6. Connect the external SCSI device making sure the external device
is properly terminated.