User`s guide

Installing Optional Disk and Tape Drives
7-16
Hot-Swap Drive Bay
Hot-swapping allows you to remove or install an SBB while the server
remains on-line and active but not accessing the device being swapped.
This eliminates interference with the server’s operation. For SBBs, you
can use the hot-swap method to replace a device providing that the device
is not active (green activity LED is off).
NOTE: Not all SCSI host adapters support the hot-swap
method. Refer to your SCSI host adapter documentation to
determine if the hot-swap method is supported.
Also, you might need to reconfigure your server to
recognize the devices you installed.
Use the following procedure to install or replace an SBB:
1. Unlock and the open right front door.
2. Remove the filler panel or SBB by pressing the two tabs together
to pull filler panel or SBB out (A, Figure 7-6).
3. Insert the new SBB into the guide slots and push it in until it is fully
seated and the mounting tabs engage the shelf.
4. Close and the lock door.