User`s guide

Installing Optional Disk and Tape Drives
7-12
Installing a Full-Height 5¼-Inch Device
into the Top-Right Drive Bay
To install a full-height 5¼-inch device into the top-right drive bay slots,
perform the following:
1. Turn off your server.
2. Disconnect all external devices, ac power, and monitor power.
3. Unlock and the remove side panels.
4. Unlock and the open door.
5. Remove both plastic filler panels by pushing them out from inside
the server.
6. Remove the bottom brackets from the inside of the drive bay and
attach them to device.
7. Remove the divider bracket (A, Figure 7-4) from the right side of
the drive bay.
8. Insert the device into the drive bay from the front.
9. Secure the device using the four supplied mounting screws.
10. If applicable, replace the plastic filler panels.