User`s guide
Table Of Contents
- Table of Contents
- About This Guide
- Introduction
- Server Front/Rear Panel Controls and Indicators
- Server Utilities
- Introduction
- SCSI Select Utility
- Flash Utility
- Using EPP3SMC.EXE
- System Configuration Utility (SCU)
- Configuring Expansion Boards
- Locating the SCU
- When to Run the SCU
- SCU Keyboard Function Keys
- Starting and Using the SCU
- Configure Your Computer
- Setting the Date and Time
- Maintain the SCU Diskette
- SCU Options
- System
- Diskette Drive Group
- Hard Disk Group
- Serial Port Group
- Parallel Port Group
- Video Options Group
- Shadow Options Group
- Cache Options Group
- Miscellaneous
- SCSI Options Group
- PCI Slot Options Group: (PCI Slots 1-3)
- Expanding Your Server
- Introduction
- Tools Needed
- Static Electricity
- Disconnect External Devices and Power
- Removing the Side Panel
- Server Components
- Main Logic Board Components
- Upgrading the CPU Module
- Upgrade Sockets and Jumper Locations
- Installing Additional Secondary Cache Memory (i486 CPU Modules)
- Installing Additional Server Memory
- Installing a SIMM
- Replacing the Server Battery/Real Time Clock (RTC)
- Installing Video Memory
- Installing Expansion Boards
- Adding Mass Storage Devices
- SCSI Configuration Guidelines
- Expansion Brackets
- Installing a Device into the Front Access Drive Bay
- Installing a Device into the Internal Drive Bay
- Connecting Diskette and IDE Devices
- Connecting SCSI Devices
- External SCSI Bus Guidelines
- A-E
- F-S
- T-Z
- Problem Solving and Troubleshooting
- Server Security Features
- Appendix A: Technical Specifications
- Appendix B: Server Messages
- Appendix C: Device Mapping
- Appendix D: Caring For Your Server
- Index
Server Utilities
3-14
Setting the Date and Time
Use these two SCU options to reset the date and time maintained by your
server’s battery. Note that it might be faster to change the date and time
using the BIOS Setup options.
To access this menu item:
1. Start the SCU from the MS-DOS partition or insert the SCU disk-
ette into drive A and soft boot (reset) your server.
2. Press [Enter] to display the SCU main menu.
3. Configure your server for the current date and time by selecting the
Set Date and Set Time options.