Technical data

Installing Expansion Boards
7-16
Relocating Expansion Boards
Perform the following steps
before
relocating an ISA expansion board and
after
relocating a PCI expansion board.
1. Start the SCU using one of the three methods described in Chapter 2,
“Starting the SCU.”
2. Select “Step 2: Add and Remove Boards.”
3. Highlight the expansion board you want to relocate, press [Enter], and
then follow the instructions displayed on your monitor screen.
4. Select “Step 4: Save Configuration,” to save your configuration.
5. Select “Step 6: Exit,” to exit the SCU.
If there are no resource conflicts, the new configuration information is
saved to the .SCI file. If there is a conflict, you must resolve it before
you can complete your server’s configuration.
NOTE:
If you run the SCU from the ServerWORKS Quick
Launch CD-ROM disk, the .SCI file is not saved. To save the .SCI
file, you need to rerun the SCU from either your hard disk drive or
from the SCU diskette you created. (Prioris XLe 6000 Series
configurations cannot run the SCU from the ServerWORKS Quick
Launch CD-ROM disc without an optional bootable CD-ROM drive
installed.)