Technical data

6-1
PRIORIS XL 6000
6
Installing Disk and Tape Drives
6
Introduction
This chapter describes the configuration guidelines that must be followed prior to
installing optional disks, a tape drive, and an external storage box. Detailed
installation procedures are also included.
Disk and Tape Drive Configuration Guidelines
•
A tape drive should be installed in the front access 5¼-inch drive bay.
•
A maximum of four 3½-inch, 1.5-inch high hard disk drives can be
installed in the internal drive bay.
or
•
A maximum of six 3½-inch, 1-inch high hard disk drives can be installed
in the internal drive bay.
CD-ROM Drive Configuration Guidelines
•
The factory installed SCSI CD-ROM drive has its SCSI ID set to 5. (The
CD-ROM drive is an option on some Prioris XLe 6000 Series
configurations.)
•
The CD-ROM drive should always be connected to the onboard Adaptec
SCSI controller to support the bootable ServerWORKS Quick Launch
CD.