Technical data

Installing Additional Memory
5-4
Installing DIMMs
NOTE:
Prior to installing additional memory in your Prioris XL 6000
Series server, refer to the previous section to verify the memory
configuration you have planned conforms to all memory
configuration guidelines.
To install DIMMs, perform the following:
1. Power down your server.
2. Disconnect all external devices, ac power, and monitor power.
3. Unlock and remove the side panel.
4. Orient the DIMM so that the two notches in the bottom edge of the
DIMM align with the keyed socket (Figure 5-2).
5. Insert the bottom edge of the DIMM into the socket and then press down
firmly on the DIMM until it seats correctly. The plastic ejector levers on
the socket ends automatically snap to the upright position (Figure 5-2)
6. Repeat the previous steps to install each DIMM.
7. Replace and lock the left side panel.
8. Connect all external devices and restore power.
9. Run the SCU to configure your server for the additional memory.
Refer to Chapter 2, “Server Software and Utilities.”