Technical data

Caring For Your Server
D-2
Cleaning the Mouse
If your mouse cursor moves erratically across the screen, the ball on the bottom
of the mouse is probably dirty.
Perform the following steps to clean a mouse ball:
1. Turn the mouse over and release the ball cover.
2. Place the mouse cover and ball on a clean surface.
3. Lightly dampen a cotton swab with a mild detergent, and clean the
ball and the inside of the mouse.
4. Replace the ball and mouse ball cover.
Moving the Server
Perform the following steps before shipping or moving the server:
1. Back up all files stored on all hard disk drives.
2. Turn off the server (the monitor automatically shuts off).
3. Disconnect power cord from wall outlet, then from the back of the
server.
4. Disconnect the monitor cable from the back of the server.
5. Disconnect the keyboard cable from the back of the server.
6. Disconnect the mouse cable from the back of the server.
7. Disconnect other external peripheral devices, such as printers
and modems.
8. Insert a drive protection card in the 3½-inch diskette drive. If you
do not have a drive protection card, use a blank diskette.
9. Package server as described in the following section, "Packing
the Server."