Technical data

SCU Features
C-2
Step 1:
About System Configuration
Use this step to learn more about configuring your system and to
obtain information about the AMI SCU..
Step 2:
Add and Remove Boards
Use this step if you want to manually add or delete ISA boards or
to move boards from one slot to another, use this step.
Step 3:
Change Configuration Settings
System Board System Board
PCI Ethernet Device Bus 0 Dev A
PCI VGA Device Bus 0 Dev 14
PCI SCSI Device Bus 0 Dev D
PCI Multifunction Device Bus 0 Dev 12
This step is optional, you may skip it by pressing [Esc] and all configuration
settings will remain unchanged.
Press [Enter] to view or change a board’s configuration settings.
Press [ESC] when you are satisfied with the current settings
Step 4:
Save Configuration
Saves the configuration settings to nonvolatile RAM and into a
backup file (the CMS File).
Step 5:
View Switch/Jumper Settings
Displays graphically what the DIP switches and jumpers are set at
on any board that has jumpers or switches.
Step 6:
Exit
Once changes have been made this step exits to the DOS
prompt.
The following tables list the SCU options that are available in the SCU.