User`s guide

Console Command Line Reference B-3

System Commands

Table B-2: System Commands

Command Description

sys-stat Show system status

get-stst-level Show the selftest level

set-stst-level Change the selftest level

warm-reset Warm reset of the device

cold-reset Cold reset of the device

get-last-err Displays information about the last fatal error

init-nvram Initializes NVRAM to default values

set-line-slip Transfers the serial line to SLIP mode

get-sw-file Retreives the SNMP Agent Software filename

set-sw-file Sets the SNMP Agent Software filename for download

get-rsw-file Retrieves the SNMP Agent Software remote filename

set-rsw-file Sets the SNMP Agent Software remote filename - for

download

get-tftp-srvr Retrieves the TFTP download server IP address

set-tftp-server Sets the TFTP download server IP address

sw-dnld Starts the SNMP Software download from the

predefined server

get-par-file Retrieves the SNMP Agent Parameters filename

set-par-file Sets the SNMP Agent Parameters filename for

automatic setup

par-upld Starts the parameter upload to the predefined server

set-fg-param Sets the Ethernet frame generator parameters

start-fg Starts the Ethernet frame generator

stop-fg Stops the Ethernet frame generator