User`s guide

Port Configuration Commands
7-40 Using the Administrative Interface
set-port-dplex
Usage:
set-port-dplex <port_number> {half|full}
The set-port-dplex command specifies if the given port will be active in full-duplex or
in half-duplex (standard Ethernet) mode. The default is half-duplex mode.
SYS_console> set-port-dplex 2 full
Port configured in <full_duplex> mode
Parameter change in NVRAM OK
SYS_console> _
NOTE
The 10 Mb/s, full-duplex, and flow control options are mutually exclusive. Full-
duplex flow control operation is available only on 100 Mb/s connections between
two MultiSwitch 300s.
set-speed-sel
Usage:
set-speed-sel <port-number> {asense|100|10}
This command specifies if the specified port number will negotiate a 10 Mb/s or 100
Mb/s connection, or if it will auto-select.
NOTE
If the switch is having difficulty auto-negotiating the wire speed, use this
command to set the correct value. The asense and full-duplex options are mutually
exclusive. You must choose a line speed before selecting full-duplex operation.
set-port-fctrl
Usage:
set-port-fctrl <port-number> {on|off}
This command specifies if the given port will have the flow control feature enabled
(on) or disabled (off). The default is flow control enabled (on).