User`s guide

Using the Administrative Interface 7-39

Port Configuration Commands

This section contains instructions for configuring and displaying the ports’ parameters

with the Administrative Interface.

get-port-cfg

The get-port-cfg command displays the current port configuration.

SYS_console> get-port-cfg

PORT_ID LAN_TYPE LINK IF_TYPE SPEED_SEL LAN_SPEED FDPLX FCTRL

===============================================================

1 ETH10/100 OFF TPFD ASENSE 100Mbps OFF ON

2 ETH10/100 OFF TPFD ASENSE 100Mbps OFF ON

3 ETH10/100 OFF TPFD ASENSE 100Mbps OFF ON

4 ETH10/100 OFF TPFD ASENSE 100Mbps OFF ON

5 ETH10/100 OFF TPFD ASENSE 100Mbps OFF ON

6 ETH10/100 OFF TPFD ASENSE 100Mbps OFF ON

7 ETH10/100 OFF TPFD ASENSE 100Mbps OFF ON

8 ETH10/100 ON TPFD ASENSE 100Mbps OFF ON

9 ETH10/100 ON TPFD ASENSE 100Mbps OFF ON

10 ETH10/100 ON TPFD ASENSE 100Mbps OFF ON

11 NONE ---- PORT NOT INSTALLED ----

12 NONE ---- PORT NOT INSTALLED ----

SYS_console>

The information displayed contains:

• The port identifier

• LAN type: ETH10 indicates 10 Mb/s Ethernet

• Link status: ON/OFF

• Physical interface type: AUI , TP , AUI-TP (AUI & TP), etc.

• Physical interface selected: AUI or TP (default)

• Full-duplex mode:

OFF = standard Ethernet (default), ON =full-duplex

• Flow control: (has no effect if full-duplex mode is enabled)

ON = enabled (default), OFF = disabled